antique wooden theater seats

Reupholstering Theater Seats

Most individuals save thousands of dollars per year by opting to do home repair projects instead of buying replacement items. Amongst these projects might be reupholstering theater seats. The expense of a new theater chair might range from $250 to $1,000 whereas the expense of reupholstering a damaged cushion might be under $50.

Items You Will Need

  • Gorilla Glue
  • Pencil
  • Paper
  • Tape measure
  • Screwdriver
  • Staples
  • Staple gun
  • Foam rubber cushion
  • Scissors
  • Fabric

 

reupholstering

 

Directions

  1. Take off the cushion(s) you want to reupholster. A few cushions are screwed into place, whereas other ones simply wedge in and easily pop out. Measure your cushion with your tape measure. Add 3″ – 6″ to the width and length to permit for the cushion depth as well as to offer excess for connecting your new seat cover. Jot your measurements down on a piece of paper.
  1. Using your pliers and screwdriver to pry the staples up, remove your old fabric from your cushion. Evaluate the cushion’s condition beneath the old fabric. If the cushion is deteriorating, unpleasantly fragrant or flat, you’ll need to replace it.
  1. Using your seat board the old cushion was connected to as a stencil, you can trace the cushion’s shape on the foam rubber and fabric’s backside with your pencil. Squeeze a good quantity of Gorilla Glue on the foam rubber’s underside. Line the foam rubber up with the seat board then press into place. Flip the seat upside-down for the cushion to be on the bottom) and allow to dry for one hour. Putting books on the seat board strengthens the adhesion.
  1. Lay your new upholstery fabric on the table with its underside face up. Put the seat cushion in the middle of the fabric with cushion side faced down. Beginning with one corner, pull the middle of the fabric taut then staple it to your seat board. Moving over to the side opposite of the staple, pull the fabric taut and place a staple in the middle. Continue with this process with the additional two sides. Prior to fully stapling an entire corner, each corner ought to have a staple in the middle, snugly pulling the fabric.
  1. Staple alongside one corner and leave around 1″ of unstapled fabric near to each edge. Once all of the sides are this far along, trim excess fabric at the corners.
  1. Pull corner fabric around to the seat board’s back firmly as you smooth any bunched up spaces out. Staple every corner at three times.
  1. Reattach your seat cushion to your theater chair. Screw in place if you originally unscrewed it.
Did you like this article?
Catch up on the latest trends in Home Decor! Receive more inspirational articles, DIY decor tips, and get the best deals on fabric. Just enter your email address below.
100% Privacy. We don't spam. Your email is safe.

Start the conversation

 
Shares